OpenWRT: Konfigurasi UBNT NanoStation2 tanpa WebGUI

Dalam salah satu contoh compile firmware di bagian sebelumnya adalah firmware OpenWRT yang sengaja di compile tanpa HTTP dan LuCI. Akibatnya, firmware tersebut jadi sangat ringan karena di operasikan tanpa WebGUI. Konfigurasinya sebetulnya relatif sederhana juga. Secara umum langkah yan perlu di lakukan ada empat (4) yaitu,

• Aktifkan Wifi menjadi adhoc network.
• Set IP address agar statik
• Set /etc/olsrd.conf
• Edit /etc/rc.local agar olsrd jalan dengan baik.

Aktifkan WiFi

Untuk mengaktifkan Wifi kita perlu mengedit,

vi /etc/config/wireless

Masukan

config wifi-device  radio0
        option type     mac80211
        option channel  1
        option macaddr  00:15:6d:da:ec:d1
        option hwmode   11g
        option antenna  auto
        option diversity 0
        option txpower  15 
        option disabled 0

config wifi-iface
        option device   radio0
        option network  mesh
        option mode     adhoc
        option ssid     MESH
        option encryption none
        option bssid    02:CA:FF:EE:BA:BE

Biasanya di konfigurasi awal /etc/config/wireless ada kata-kata

# REMOVE THIS LINE TO ENABLE WIFI:
option disabled 1

Ubah menjadi option disable 0

Konfigurasi IP address Wireless

Edit konfigurasi IP address untuk wireless,

vi /etc/config/network

Masukan

config interface mesh
       option ifname   wlan0
       option type     bridge
       option proto    static
       option ipaddr   172.16.123.12
       option netmask  255.255.0.0

restart network

/etc/init.d/network restart

cek di console apakah sudah operasional dengan baik, ketik perintah

iwconfig 

akan keluar kurang lebih

wlan0     IEEE 802.11bg  ESSID:"MESH"  
          Mode:Ad-Hoc  Frequency:2.412 GHz  Cell: 02:CA:FF:EE:BA:BE   
          Tx-Power=15 dBm   
          RTS thr:off   Fragment thr:off
          Encryption key:off
          Power Management:on
        

Konfigurasi OLSR

Edit konfigurasi olsrd

vi /etc/olsrd.conf

Masukan

Hna4
{                     
} 
Hna6  
{                                                    
}
LoadPlugin "olsrd_txtinfo.so.0.1"
{
    PlParam  "accept" "0.0.0.0"                                              
} 
InterfaceDefaults  
{                        
}
Interface "wlan0" "eth0" "br-lan"
{
     Mode "mesh"
}

Masukan rc.local

masukan ke /etc/rc.local

ifconfig wlan0 172.16.123.12
/etc/init.d/olsrd stop
rm /var/run/olsrd-ipv4.lock 
olsrd -f /etc/olsrd.conf &

reboot

Selesai sudah proses konfigurasi UBNT NanoStation2 agar menjadi Mesh Node, kita perlu me-restart menggunakan perintah

reboot

Pranala Menarik

• OpenWRT
• OpenWRT: Download Firmware yang sudah jadi
• OpenWRT: Source Repository Download
• OpenWRT: Melihat Daftar Package

Build Firmware

• OpenWRT: Build Firmware
• OpenWRT: Build Firmware Download Source Pendukung
• OpenWRT: Build Firmware Buffalo WZRHPG450H
• OpenWRT: Build Firmware Buffalo WZRHPG300N
• OpenWRT: Build Firmware Buffalo WZRHPG300NH2
• Buffalo
• Buffalo: WZRHPG450H Cara Recovery
• Buffalo: WZRHPG450H OpenWRT mengaktifkan setelah di flash
• Buffalo: WZRHPG450H Membuat Firmware OpenWRT Sendiri RECOMMENDED
• Buffalo: WZRHPG450H OpenWRT instalasi aplikasi Pendukung OLSRD
• OpenWRT: Build Firmware Ubiquiti NanoStation2 RECOMMENDED
• OpenWRT: Build Firmware Ubiquiti NanoStationM2 RECOMMENDED
• OpenWRT: Build Firmware Mikrotik RB433
• OpenWRT: Build Firmware Linksys WRT160NL
• OpenWRT: Build Firmware Linksys WRT54GL

APRX

• OpenWRT: Build Firmware Buffalo WZRHPG300NH2 untuk APRX

IPv6

• OpenWRT: IPv6
• OpenWRT IPv6: Build Firmware Linksys WRT160NL
• OpenWRT IPv6: Build Firmware Linksys WRT160NL Tanpa WebGUI
• OpenWRT IPv6: Build Firmware Buffalo WZRHPG450H
• OpenWRT IPv6: Build Firmware Buffalo WZRHPG300NH2
• OpenWRT IPv6: Setup tunnel ke tunnelbroker
• OpenWRT IPv6: Konfigurasi
• OpenWRT IPv6: Konfigurasi WAN6 dengan radvd

Flash Firmware

• OpenWRT: Flash Linksys WRT54GL
• OpenWRT: Flash Linksys WRT160NL
• OpenWRT: Flash Buffalo WZRHP450H RECOMMENDED
• OpenWRT: Flash Buffalo WZRHP300N
• OpenWRT: Flash UBNT NanoStation2 RECOMMENDED
• OpenWRT: Flash UBNT NanoStation M2 RECOMMENDED
• OpenWRT: Flash UBNT NanoStation Loco M2
• OpenWRT: Flash UBNT Bullet M2 RECOMMENDED
• OpenWRT: Flash Mikrotik RB433 RECOMMENDED
• OpenWRT: Flash Mikrotik RB450

Misc

• OpenWRT: Setup WiFi
• OpenWRT: Setup PPTP VPN Server
• OpenWRT: Setup OLSR di UBNT via CLI RECOMMENDED
• OpenWRT: Mikrotik RB433
• OpenWRT: Setup OLSR Sederhana
• OLSR - di OpenWRT
• OpenWRT: 3G modem
• OpenWRT: Build Firmware dengan 3G Modem Support
• OpenWRT: Setup Firewall
• OpenWRT: Konfigurasi UBNT NanoStation2 tanpa WebGUI

UBNT

• UBNT
• UBNT: Teknik Recovery
• UBNT: Upload Firmware
• UBNT: Rebuild Firmware
• UBNT: firmware dengan OLSR
• UBNT: openwrt
• UBNT: olsr dengan openwrt
• UBNT: olsr dengan kamikaze openwrt
• UBNT: olsr dengan backfire openwrt RECOMMENDED
• UBNT: UniFi
• UBNT: UniFi Konfigurasi Awal
• UBNT: UniFi Manajemen HotSpot
• UBNT: OLSR Pembuatan Firmware
• UBNT: OLSR Konfigurasi
• OLSR - di UBNT
• OLSR - di Ubuntu
• OpenWRT
• OLSR: NAT di UBNT dengan OLSR