OpenWRT: Setup OLSR Sederhana
Setup Wireless MESH
Melalui Web
Administration > Network > Wifi > Scan
Klik pada jaringan MESH yang ada.
Setup Wireless IP Address Statik
Melalui Web
Administration > Network > Interfaces > Klik wireless interface
General Setup > Protocol > Static Address > IPv4 address > 10.x.x.x
General Setup > Protocol > Static Address > IPv4 netmask > 255.0.0.0
Pastikan IP address yang digunakan berbeda dengan teman-teman yang lain agar tidak tabrakan.
Setup Firewall untuk jadi gateway
Jika di perlukan agar proxy / NAT ke Internet bisa beroperasi dengan baik.
Melalui Web
Administation > Network > Firewall
Klik pada zone wireless
Advanced Setting > destination zones > klik WAN
Setup OLSR menggunakan shell
Edit
vi /etc/olsrd.conf
Masukan
Hna4
{
# 192.168.0.0 255.255.255.0 - gateway ke 192.168.0.0/24
# 0.0.0.0 0.0.0.0 - gateway ke internet
}
Hna6
{
}
LoadPlugin "olsrd_nameservice.so.0.3"
{
}
LoadPlugin "olsrd_txtinfo.so.0.1"
{
PlParam "accept" "0.0.0.0"
}
InterfaceDefaults
{
}
Interface "wlan0"
{
Mode "mesh"
}
Edit
vi /etc/rc.local
Masukan
/etc/init.d/olsrd stop olsrd -f /etc/olsrd.conf &
Pranala Menarik
- OpenWRT
- OpenWRT: Download Firmware yang sudah jadi
- OpenWRT: Source Repository Download
- OpenWRT: Melihat Daftar Package
Build Firmware
- OpenWRT: Build Firmware
- OpenWRT: Build Firmware Buffalo WZRHPG450H
- OpenWRT: Build Firmware Buffalo WZRHPG300N
- Buffalo
- Buffalo: WZRHPG450H Cara Recovery
- Buffalo: WZRHPG450H OpenWRT mengaktifkan setelah di flash
- Buffalo: WZRHPG450H Membuat Firmware OpenWRT Sendiri COOL
- Buffalo: WZRHPG450H OpenWRT instalasi aplikasi Pendukung OLSRD
- OpenWRT: Build Firmware Ubiquiti NanoStation2
- OpenWRT: Build Firmware Mikrotik RB433
- OpenWRT: Build Firmware Linksys WRT160NL
- OpenWRT: Build Firmware Linksys WRT54GL
Build Firmware
- OpenWRT: Flash Linksys WRT54GL
- OpenWRT: Flash Linksys WRT160NL
- OpenWRT: Flash Buffalo WZRHP450H
- OpenWRT: Flash Buffalo WZRHP300N
- OpenWRT: Flash UBNT NanoStation2