Network Bonding di Ubuntu
Jump to navigation
Jump to search
Ethernet bonding howto in Ubuntu 10.10 January 9, 2011ricoch3nLeave a commentGo to comments Tested in 64bit environment.
1) echo “alias bond0 bonding” > /etc/modprobe.d/bonding.conf 2) apt-get install ifenslave 3) edit /etc/network/interfaces as follows
# The loopback network interface auto lo iface lo inet loopback
auto bond0 iface bond0 inet static # change the next three lines according to actual network settings address 192.168.1.200 gateway 192.168.1.1 netmask 255.255.255.0 slaves eth0 eth1 bond-mode balance-rr bond-miimon 100 bond-primary eth0 eth1 up /sbin/ifenslave bond0 eth0 eth1 down /sbin/ifenslave -d bond0 eth0 eth1
4) either do a complete system reboot or the following:
a) /etc/inti.d/networking restart b) ifconfig eth0 0 (and ignore the error, this [ and the next ] command will delete what ever ip address that eth0 has been originally set to) c) ifconfig eth1 0 d) adjust the routes if necessary, mostly the default route needs to be replaced (change to via bond0 instead of eth0 or eth1, for example:
route del default dev eth0
or
route del default dev eth1
)
Regardless which method is chosen in step 4, it’s usually safer to change the network setting through a local console instead of a remote ssh session.
Source: https://help.ubuntu.com/community/UbuntuBonding