Cisco: Static Routing Sedehana
Revision as of 05:51, 22 December 2018 by Onnowpurbo (talk | contribs) (→Tambahan Kalau Membutuhkan NAT)
R1:
Ethernet1/1 - ke Internet Ethernet1/2 - R2: Ethernet 1/1 Ethernet1/3 - LAN
R2:
Ethernet1/1 - R1: Ethernet1/2 Ethernet1/2 - LAN
R1:
enable configure terminal interface ethernet1/1 ip address 10.1.1.2 255.255.255.0 # static ke internet ip address dhcp # dhcp ke internet no shutdown exit interface ethernet1/2 ip address 172.16.1.1 255.255.255.252 no shutdown exit interface ethernet1/3 ip address 192.168.1.1 255.255.255.0 no shutdown exit ip route 192.168.2.0 255.255.255.0 172.16.1.2 exit copy running-config startup-config
R2:
enable config terminal interface ethernet1/1 ip address 172.16.1.2 255.255.255.252 no shutdown exit interface ethernet1/2 ip address 192.168.2.1 255.255.255.0 no shutdown exit ip route 192.168.1.0 255.255.255.0 172.16.1.1 ip route 0.0.0.0 0.0.0.0 172.16.1.1 exit copy running-config startup-config
Request DHCP
enable config terminal interface ethernet1/1 ip dhcp client request exit exit
Test
R1:
ping 192.168.2.1
R2:
ping 192.168.1.1
Tambahan Kalau Membutuhkan NAT
Router1:
Using NAT to Allow Internal Users Access to the Internet
Perform this task to allow your internal users access to the Internet and conserve addresses in the inside global address pool using overloading of global addresses.
SUMMARY STEPS
enable configure terminal ip nat pool name start-ip end-ip {netmask netmask | prefix-length prefix-length } access-list access-list-number permit source [source-wildcard ] ip nat inside source list access-list-number pool name overload interface type number ip address ip-address mask ip nat inside exit interface type number ip address ip-address mask ip nat outside end
Referensi
Setting Client
LAN 1 Client:
ip 192.168.1.2 gw 192.168.1.1
LAN 2 Client:
ip 192.168.2.2 gw 192.168.2.1