Difference between revisions of "Postfix: IPv6"

Latest revision as of 10:46, 12 June 2020

Sumber: http://www.postfix.org/IPV6_README.html

Sejak Postfix 2.2, IPv6 sudah mulai di dukung oleh Postfix dengan menggunakan protocol SMTP yang sama hanya saja menggunakan record AAAA di DNS-nya.

Konfigurasi

Untuk operasional Postfix pada IPv6 ada dua (2) tambahan parameter di /etc/postfix/main.cf, yaitu

Semua IPv6 address harus masuk dalam "[]".
loopback menggunakan "inet_interfaces = loopback-only" di main.cf

Beberapa contoh setup parameter di main.cf

inet_protocols

Contoh parameter inet_protocols

/etc/postfix/main.cf:
     # You must stop/start Postfix after changing this parameter.
     inet_protocols = ipv4       (DEFAULT: enable IPv4 only)
     inet_protocols = all        (enable IPv4, and IPv6 if supported)
     inet_protocols = ipv4, ipv6 (enable both IPv4 and IPv6)
     inet_protocols = ipv6       (enable IPv6 only)

SMTP bind IPv6 address

Contoh parameter smtp_bind_address6

/etc/postfix/main.cf:
     smtp_bind_address6 = 2001:240:587:0:250:56ff:fe89:1

mynetwork

Contoh parameter mynetworks

/etc/postfix/main.cf:
       mynetworks = 127.0.0.0/8 168.100.189.0/28 [::1]/128 [fe80::]/10 [2001:240:587::]/64

/etc/postfix/main.cf:
       mynetworks = ...IPv4 networks... [::1]/128 [2001:240:587::]/64 ...

Referensi

http://www.postfix.org/IPV6_README.html

Pranala Menarik

Postfix
IPv6

@@ Line 1: / Line 1: @@
 Sumber: http://www.postfix.org/IPV6_README.html
+Sejak Postfix 2.2, IPv6 sudah mulai di dukung oleh Postfix dengan menggunakan protocol SMTP yang sama hanya saja menggunakan record AAAA di DNS-nya.
-Introduction
-Postfix 2.2 introduces support for the IPv6 (IP version 6) protocol. IPv6 support for older Postfix versions was available as an add-on patch. The section "Compatibility with Postfix <2.2 IPv6 support" below discusses the differences between these implementations.
+==Konfigurasi==
-The main feature of interest is that IPv6 uses 128-bit IP addresses instead of the 32-bit addresses used by IPv4. It can therefore accommodate a much larger number of hosts and networks without ugly kluges such as NAT. A side benefit of the much larger address space is that it makes random network scanning impractical.
+Untuk operasional Postfix pada IPv6 ada dua (2) tambahan parameter di /etc/postfix/main.cf, yaitu
-Postfix uses the same SMTP protocol over IPv6 as it already uses over the older IPv4 network, and does AAAA record lookups in the DNS in addition to the older A records. Information about IPv6 can be found at http://www.ipv6.org/.
+* Semua IPv6 address harus masuk dalam "[]".
+* loopback menggunakan "inet_interfaces = loopback-only" di main.cf
-This document provides information on the following topics:
+Beberapa contoh setup parameter di main.cf
-    Supported platforms
+===inet_protocols===
-    Configuration
-    Known limitations
-    Compatibility with Postfix <2.2 IPv6 support
-    IPv6 Support for unsupported platforms
-    Credits
-Supported Platforms
+Contoh parameter inet_protocols
-Postfix version 2.2 supports IPv4 and IPv6 on the following platforms:
+ /etc/postfix/main.cf:
+      # You must stop/start Postfix after changing this parameter.
+      inet_protocols = ipv4       (DEFAULT: enable IPv4 only)
+      inet_protocols = all        (enable IPv4, and IPv6 if supported)
+      inet_protocols = ipv4, ipv6 (enable both IPv4 and IPv6)
+      inet_protocols = ipv6       (enable IPv6 only)
-    AIX 5.1+
+===SMTP bind IPv6 address===
-    Darwin 7.3+
-    FreeBSD 4+
-    Linux 2.4+
-    NetBSD 1.5+
-    OpenBSD 2+
-    Solaris 8+
-    Tru64Unix V5.1+
-On other platforms Postfix will simply use IPv4 as it has always done.
+Contoh parameter smtp_bind_address6
-See below for tips how to port Postfix IPv6 support to other environments.
+ /etc/postfix/main.cf:
-Configuration
+      smtp_bind_address6 = 2001:240:587:0:250:56ff:fe89:1
-Postfix IPv6 support introduces two new main.cf configuration parameters, and introduces an important change in address syntax notation in match lists such as mynetworks or debug_peer_list.
+===mynetwork===
-Postfix IPv6 address syntax is a little tricky, because there are a few places where you must enclose an IPv6 address inside "[]" characters, and a few places where you must not. It is a good idea to use "[]" only in the few places where you have to. Check out the postconf(5) manual whenever you do IPv6 related configuration work with Postfix.
+Contoh parameter mynetworks
-    Instead of hard-coding 127.0.0.1 and ::1 loopback addresses in master.cf, specify "inet_interfaces = loopback-only" in main.cf. This way you can use the same master.cf file regardless of whether or not Postfix will run on an IPv6-enabled system.
+ /etc/postfix/main.cf:
-    The first new parameter is called inet_protocols. This specifies what protocols Postfix will use when it makes or accepts network connections, and also controls what DNS lookups Postfix will use when it makes network connections.
-        /etc/postfix/main.cf:
-            # You must stop/start Postfix after changing this parameter.
-            inet_protocols = ipv4       (DEFAULT: enable IPv4 only)
-            inet_protocols = all        (enable IPv4, and IPv6 if supported)
-            inet_protocols = ipv4, ipv6 (enable both IPv4 and IPv6)
-            inet_protocols = ipv6       (enable IPv6 only)
-    By default, Postfix uses IPv4 only, because most systems aren't attached to an IPv6 network.
-        On systems with combined IPv4/IPv6 stacks, attempts to deliver mail via IPv6 would always fail with "network unreachable", and those attempts would only slow down Postfix.
-        Linux kernels don't even load IPv6 protocol support by default. Any attempt to use it would fail immediately.
-    Note 1: you must stop and start Postfix after changing the inet_protocols configuration parameter.
-    Note 2: if you see error messages like the following, then you're running Linux and need to turn on IPv6 in the kernel: see http://www.ipv6.org/ for hints and tips. Unlike other systems, Linux does not have a combined stack for IPv4 and IPv6, and IPv6 protocol support is not loaded by default.
-        postconf: warning: inet_protocols: IPv6 support is disabled: Address family not supported by protocol
-        postconf: warning: inet_protocols: configuring for IPv4 support only
-    Note 3: on older Linux and Solaris systems, the setting "inet_protocols = ipv6" will not prevent Postfix from accepting IPv4 connections. Postfix will present the client IP addresses in IPv6 format, though. In all other cases, Postfix always presents IPv4 client IP addresses in the traditional dotted quad IPv4 format.
-    The other new parameter is smtp_bind_address6. This sets the local interface address for outgoing IPv6 SMTP connections, just like the smtp_bind_address parameter does for IPv4:
-        /etc/postfix/main.cf:
-            smtp_bind_address6 = 2001:240:587:0:250:56ff:fe89:1
-    If you left the value of the mynetworks parameter at its default (i.e. no mynetworks setting in main.cf) Postfix will figure out by itself what its network addresses are. This is what a typical setting looks like:
-        % postconf mynetworks
          mynetworks = 127.0.0.0/8 168.100.189.0/28 [::1]/128 [fe80::]/10 [2001:240:587::]/64
-    If you did specify the mynetworks parameter value in main.cf, you need update the mynetworks value to include the IPv6 networks the system is in. Be sure to specify IPv6 address information inside "[]", like this:
+ /etc/postfix/main.cf:
+        mynetworks = ...IPv4 networks... [::1]/128 [2001:240:587::]/64 ...
-        /etc/postfix/main.cf:
-            mynetworks = ...IPv4 networks... [::1]/128 [2001:240:587::]/64 ...
-NOTE: when configuring Postfix match lists such as mynetworks or debug_peer_list, you must specify IPv6 address information inside "[]" in the main.cf parameter value and in files specified with a "/file/name" pattern. IPv6 addresses contain the ":" character, and would otherwise be confused with a "type:table" pattern.
+==Referensi==
+* http://www.postfix.org/IPV6_README.html
+==Pranala Menarik==
+* [[Postfix]]
-==Referensi==
+* [[IPv6]]
-* http://www.postfix.org/IPV6_README.html