Arduino: Analog Read Serial

From OnnoWiki
Revision as of 05:05, 9 February 2022 by Onnowpurbo (talk | contribs) (→‎Code)
Jump to navigation Jump to search

Sumber: https://www.arduino.cc/en/Tutorial/AnalogReadSerial


Hardware Required

  • Arduino / Genuino Board
  • 10k ohm Potentiometer


Rangkaian

AnalogReadSerial BB.png
AnalogReadSerial sch.png


Code

/*
  AnalogReadSerial
  Reads an analog input on pin 0, prints the result to the serial monitor.
  Graphical representation is available using serial plotter (Tools > Serial Plotter menu)
  Attach the center pin of a potentiometer to pin A0, and the outside pins to +5V and ground.

  This example code is in the public domain.
*/

// the setup routine runs once when you press reset:
void setup() {
  // initialize serial communication at 9600 bits per second:
  Serial.begin(9600);
}

// the loop routine runs over and over again forever:
void loop() {
  // read the input on analog pin 0:
  int sensorValue = analogRead(A0);
  // print out the value you read:
  Serial.println(sensorValue);
  delay(1);        // delay in between reads for stability
}


Code Indonesia

/*

 AnalogReadSerial
 Baca analog input di pin 0, prints hasil ke serial monitor.
 Kita dapat menyambungkan pin tengah potensiometer di pin A0, dan dua (2) lainnya ke +5V  dan ground.
  • /

void setup() {

 // serial monitor via USB pada kecepatan 9600bps
 Serial.begin(9600);

}

void loop() {

 // baca analog pin A0:
 int sensorValue = analogRead(A0);
 // kirim nilai ke serial monitor
 Serial.println(sensorValue);
 delay(1);        // delay antar read

}

Referensi