Difference between revisions of "Arduino: Analog Read Serial"

From OnnoWiki
Jump to navigation Jump to search
(New page: Sumber: https://www.arduino.cc/en/Tutorial/AnalogReadSerial ==Hardware Required== * Arduino / Genuino Board * 10k ohm Potentiometer ==Rangkaian== [[Image:AnalogReadSerial BB.png|cen...)
 
 
(One intermediate revision by the same user not shown)
Line 43: Line 43:
  
  
 +
==Code Indonesia==
 +
 +
/*
 +
  AnalogReadSerial
 +
  Baca analog input di pin 0, prints hasil ke serial monitor.
 +
  Kita dapat menyambungkan pin tengah potensiometer di pin A0, dan dua (2) lainnya ke +5V  dan ground.
 +
*/
 +
 +
void setup() {
 +
  // serial monitor via USB pada kecepatan 9600bps
 +
  Serial.begin(9600);
 +
}
 +
 +
void loop() {
 +
  // baca analog pin A0:
 +
  int sensorValue = analogRead(A0);
 +
  // kirim nilai ke serial monitor
 +
  Serial.println(sensorValue);
 +
  delay(1);        // delay antar read
 +
}
  
 
==Referensi==
 
==Referensi==
  
 
* https://www.arduino.cc/en/Tutorial/AnalogReadSerial
 
* https://www.arduino.cc/en/Tutorial/AnalogReadSerial

Latest revision as of 05:05, 9 February 2022

Sumber: https://www.arduino.cc/en/Tutorial/AnalogReadSerial


Hardware Required

  • Arduino / Genuino Board
  • 10k ohm Potentiometer


Rangkaian

AnalogReadSerial BB.png
AnalogReadSerial sch.png


Code

/*
  AnalogReadSerial
  Reads an analog input on pin 0, prints the result to the serial monitor.
  Graphical representation is available using serial plotter (Tools > Serial Plotter menu)
  Attach the center pin of a potentiometer to pin A0, and the outside pins to +5V and ground.

  This example code is in the public domain.
*/

// the setup routine runs once when you press reset:
void setup() {
  // initialize serial communication at 9600 bits per second:
  Serial.begin(9600);
}

// the loop routine runs over and over again forever:
void loop() {
  // read the input on analog pin 0:
  int sensorValue = analogRead(A0);
  // print out the value you read:
  Serial.println(sensorValue);
  delay(1);        // delay in between reads for stability
}


Code Indonesia

/*
  AnalogReadSerial
  Baca analog input di pin 0, prints hasil ke serial monitor.
  Kita dapat menyambungkan pin tengah potensiometer di pin A0, dan dua (2) lainnya ke +5V  dan ground.
*/

void setup() {

 // serial monitor via USB pada kecepatan 9600bps
 Serial.begin(9600);

}

void loop() {

 // baca analog pin A0:
 int sensorValue = analogRead(A0);
 // kirim nilai ke serial monitor
 Serial.println(sensorValue);
 delay(1);        // delay antar read

}

Referensi