Digital Ampere Meter: Callibration

From OnnoWiki
Revision as of 06:13, 26 February 2020 by Onnowpurbo (talk | contribs) (Created page with "==Calibration and Zero Adjustment== Periodic adjustment of the meter is possible. With the meter turned off (power removed), apply a short (jumper) between test points A and...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

Calibration and Zero Adjustment

Periodic adjustment of the meter is possible. With the meter turned off (power removed), apply a short (jumper) between test points A and B. With the jumper in place, apply power to the meter which will be automatically calibrated to zero. Remove the jumper placed between A and B.

The current display can also be adjusted through the trim pot R7. Simply apply a known current across the meter of approximately 25A (mid-way between the maximum value). Adjust R7 until the meter displays the correct current reading. Digital Panel Meter - Voltage and Current - Calibration and Zero Adjustment


DVAM-02-Calibration.jpg