Linux: Interface BONDING
Revision as of 05:43, 30 September 2019 by Onnowpurbo (talk | contribs)
Sumber: https://help.ubuntu.com/community/UbuntuBonding
Aktifkan Module
sudo su vi /etc/modules
# /etc/modules: kernel modules to load at boot time. # # This file contains the names of kernel modules that should be loaded # at boot time, one per line. Lines beginning with "#" are ignored. loop lp rtc bonding
Aktifkan module
modprobe --first-time bonding modprobe bonding modinfo bonding | more
Edit Interface
sudo vi /etc/network/interfaces
# eth0 is manually configured, and slave to the "bond0" bonded NIC
auto eth0
iface eth0 inet manual
bond-master bond0
bond-primary eth0
# eth1 ditto, thus creating a 2-link bond.
auto eth1
iface eth1 inet manual
bond-master bond0
# bond0 is the bonding NIC and can be used like any other normal NIC.
# bond0 is configured using static network information.
auto bond0
iface bond0 inet static
address 192.168.1.10
gateway 192.168.1.1
netmask 255.255.255.0
bond-mode active-backup
bond-miimon 100
bond-slaves none
Aktifasi Bonding
sudo start networking
Cek
cat /proc/net/bonding/bond0
ifconfig