Cisco: OSPF Sederhana - dengan MD5 Authentication
Revision as of 09:07, 28 December 2018 by Onnowpurbo (talk | contribs) (Created page with "center|900px|thumb Router1: enable configure terminal interface ethernet1/1 ip address 10.10.1.1 255.255.255.252 no shutdown exit...")
Router1:
enable configure terminal interface ethernet1/1 ip address 10.10.1.1 255.255.255.252 no shutdown exit interface ethernet1/2 ip address 10.10.1.5 255.255.255.252 no shutdown exit ! ! NAT GNS3 gw 192.168.122.1 interface ethernet1/3 ip address 192.168.122.100 255.255.255.0 ip address 192.168.122.101 255.255.255.0 secondary ip address 192.168.122.102 255.255.255.0 secondary no shutdown ip route 0.0.0.0 0.0.0.0 192.168.122.1 end
Router2:
enable configure terminal interface ethernet1/1 ip address 10.10.1.6 255.255.255.252 no shutdown exit interface ethernet1/2 ip address 10.10.1.9 255.255.255.252 no shutdown exit interface ethernet1/3 ip address 172.16.1.1 255.255.0.0 no shutdown end
Router3:
enable configure terminal interface ethernet1/1 ip address 10.10.1.2 255.255.255.252 no shutdown exit interface ethernet1/2 ip address 10.10.1.10 255.255.255.252 no shutdown exit interface ethernet1/3 ip address 192.168.1.1 255.255.255.0 no shutdown end
Ada tiga (3) elemen dasar konfigurasi OSPF:
- Enable OSPF instance
- OSPF area configuration
- OSPF network configuration
Catatan: Ingat bahwa backbone area-id adalah 0.0.0.0.
R1
enable configure terminal ! ! area 0 = backbone router ospf 1 network 10.10.1.0 0.0.0.3 area 0.0.0.0 network 10.10.1.4 0.0.0.3 area 0.0.0.0 end
R2
enable configure terminal ! ! area 0 = backbone router ospf 2 network 10.10.1.4 0.0.0.3 area 0.0.0.0 network 10.10.1.8 0.0.0.3 area 0.0.0.0 network 172.16.0.0 0.0.255.255 area 0.0.0.0 end
R3
enable configure terminal ! ! area 0 = backbone router ospf 3 network 10.10.1.0 0.0.0.3 area 0.0.0.0 network 10.10.1.8 0.0.0.3 area 0.0.0.0 network 192.168.1.0 0.0.0.255 area 0.0.0.0 end
Verify
Cek di R1, R2, R3
show ip ospf neighbor show ip ospf database show ip route
Referensi