Arduino: Digital Read Serial

Sumber: https://www.arduino.cc/en/Tutorial/DigitalReadSerial

Hardware Required

• Arduino or Genuino Board
• A momentary switch, button, or toggle switch
• 10k ohm resistor
• hook-up wires
• breadboard

Rangkaian

Code

/*
  DigitalReadSerial
 Reads a digital input on pin 2, prints the result to the serial monitor

 This example code is in the public domain.
 */

// digital pin 2 has a pushbutton attached to it. Give it a name:
int pushButton = 2;

// the setup routine runs once when you press reset:
void setup() {
  // initialize serial communication at 9600 bits per second:
  Serial.begin(9600);
  // make the pushbutton's pin an input:
  pinMode(pushButton, INPUT);
}

// the loop routine runs over and over again forever:
void loop() {
  // read the input pin:
  int buttonState = digitalRead(pushButton);
  // print out the state of the button:
  Serial.println(buttonState);
  delay(1);        // delay in between reads for stability
}

Referensi

• https://www.arduino.cc/en/Tutorial/DigitalReadSerial