APRS4R
Revision as of 08:52, 20 November 2013 by Onnowpurbo (talk | contribs)
Start Page Index History Last Change
OpenWrt APRS4R installation installation via shell script
To install the APRS4R software via script, you have to download the installation script from the APRS4R website and execute the script on your router. Please execute following commands on the shell prompt of your router.
download installation script
root@OpenWrt:/# cd /tmp root@OpenWrt:~# wget http://www.aprs4r.org/download/openwrt-aprs4r-install.sh
start installation
root@OpenWrt:~# sh openwrt-aprs4r-install.sh
manual installation
This section describes the manual installation of the APRS4R software on an OpenWrt router. This guide is focused on the OpenWrt release Kamikaze 07.09 (October 2007), the older Whiterussian release is not supported any more.
install additional kernel modules
To use USB-serial-adapters to connect your TNC or weather station, please run following commands on the routers console.
root@OpenWrt:/# ipkg update
root@OpenWrt:/# ipkg install kmod-usb-serial-pl2303 kmod-usb-serial-ftdi kmod-usb-serial-belkin
install Ruby packages
A working Ruby run time system is required to run the APRS4R software, please run following commands.
root@OpenWrt:/# ipkg install ruby ruby-core ruby-yaml ruby-cgi
setup APRS4R packet repository
To install the APRS4R software, at first the setup of a additional packet repository is mandatory. Please append following line to your /etc/ipkg.conf.
src aprs4r http://www.aprs4r.org/openwrt/kamikaze
Please run
root@OpenWrt:/# ipkg update
to update packet management information.
install APRS4R packets
The APRS4R software is splitted into three packets. The packet aprs4r contains the core APRS4R software, whereas the packet aprs4r-web represents the web interface. The packet aprs4web provides a browser based visualisation of your local APRS traffic.
To install all packages, please run following command.
root@OpenWrt:/# ipkg install aprs4r aprs4r-web aprs4web