IPv6 Route: FAQ IPv6 Route

From OnnoWiki
Revision as of 08:32, 23 May 2013 by Onnowpurbo (talk | contribs)
Jump to navigation Jump to search

Dukungan untuk route default IPv6

Salah satu idea dari IPv6 adalah routing hierarkis, oleh karenanya akan lebih sedikit routing entri di butuhkan di router. Ada beberapa isu di kernel linux saat ini


Client (tidak merouting paket)

Client can setup a default route like prefix “::/0”, they also learn such route on autoconfiguration e.g. using radvd on the link like following example shows:

# ip -6 route show | grep ^default
default via fe80::212:34ff:fe12:3450 dev eth0 proto kernel metric 1024 expires 29sec mtu 1500 advmss 1440

7.6.1.2. Routers in case of packet forwarding

Older Linux kernel (at least <= 2.4.17) don't support default routes. You can set them up, but the route lookup fails when a packet should be forwarded (normal intention of a router). If you're still using such older kernel, “default routing” can be setup using the currently used global address prefix “2000::/3”.

Note: take care about default routing without address filtering on edge routers. Otherwise unwanted multicast or site-local traffic can leave the edge.