OpenWRT: Flash Buffalo WZRHP300N
Sumber: http://wiki.openwrt.org/toh/buffalo/whr-hp-g300n
Set your ethernet interface ip on 192.168.11.2
Set your ethernet interface netmask on 255.255.255.0
Add arp entry for 192.168.11.1 when the ethernet interface is up
sudo arp -s 192.168.11.1 aa:bb:cc:dd:ee:ff
Download the tftp version of the right firmware Change the directory of your prompt to the firmware download directory cd /Users/yourname/Downloads/
Send your firware image with tftp
tftp 192.168.11.1
- from this point, you're under tftp command prompt, the "tftp>" is the prompt tftp gives you, you just need to type the command AFTER that.
tftp> verbose
tftp> binary
tftp> trace
tftp> rexmt 1
tftp> timeout 60
Power on your router on and plug your ethernet on a LAN port
Send the command put until is success
tftp> put linux.bin
putting linux.bin to 192.168.11.1:linux.bin [octet] sent WRQ <file=linux.bin, mode=octet> tftp: sendto: Can't assign requested address
tftp> put linux.bin