IPv6-ready tool konfigurasi network

From OnnoWiki
Revision as of 09:54, 22 June 2013 by Onnowpurbo (talk | contribs)
Jump to navigation Jump to search


You wont get very far, if you are running an IPv6-ready kernel, but have no tools to configure IPv6. There are several packages in existence which can configure IPv6.

Paket net-tools

The net-tool package includes some tools like ifconfig and route, which helps you to configure IPv6 on an interface. Look at the output of ifconfig -? or route -?, if something is shown like IPv6 or inet6, then the tool is IPv6-ready.

Auto-magically check:

# /sbin/ifconfig -? 2>& 1|grep -qw 'inet6' && echo "utility 'ifconfig' is IPv6-ready"

Same check can be done for route:

# /sbin/route -? 2>& 1|grep -qw 'inet6' && echo "utility 'route' is IPv6-ready"

Paket iproute

Alexey N. Kuznetsov (current a maintainer of the Linux networking code) created a tool-set which configures networks through the netlink device. Using this tool-set you have more functionality than net-tools provides, but its not very well documented and isn't for the faint of heart.

# /sbin/ip 2>&1 |grep -qw 'inet6' && echo "utility 'ip' is IPv6-ready"

If the program /sbin/ip isn't found, then I strongly recommend you install the iproute package.

   You can get it from your Linux distribution (if contained)
   You're able to look for a proper RPM package at RPMfind/iproute (sometimes rebuilding of a SRPMS package is recommended)