UBNT: openwrt

Sumber: http://wiki.ubnt.com/Installing_OpenWRT_on_NanoStations/Bullets

Berikut adalah prosedur untuk mem-flash Ubiquiti Bullet 2 atau Nano2/Loco2. Prosedur ini akan mengganti AirOS firmware dengan OpenWRT firmware.

WARNING: penggunaan firmware ini akan men-disable beberapa fungsi device, seperti LED dan Ubiquiti Web interface. Kita dapat mengembalikannya melalui “Recovery of Ubiquiti firmware”

Download OpenWRT firmware untuk Ubiquiti dari

Requirements

   - A computer running Microsoft Windows (Windows XP, Vista or 7) 
   - Direct Ethernet cable connection between PC and Bullet, Pico or Nano/Loco. 
   - Network settings of PC: IP address: 192.168.1.254 and net mask: 255.255.255.0 
   - TFTP client on PC (TFTPD32 is recommended) 
   - OpenWRT firmware file. You can download it from here: 
   For Nano2 or Bullet2 devices: http://kamikaze.openwrt.org/8.09.1/atheros/openwrt-atheros-ubnt2-squashfs.bin 
   For Nano5 or Bullet5 devices: http://kamikaze.openwrt.org/8.09.1/atheros/openwrt-atheros-ubnt5-squashfs.bin 
   For Pico2 devices: http://kamikaze.openwrt.org/8.09.1/atheros/openwrt-atheros-ubnt2-pico2-squashfs.bin

Steps

   - First of all, disconnect the Ethernet cable from Pico, Bullet2 or Nano/Loco2. 
   - Connect the Ethernet Cable and immediately press the Reset button (near the device’s RJ45 connector) for 10 seconds. 
   - Make sure that device responds to pinging (command: ping 192.168.1.20, by default). If not, please repeat previous steps. 
   - Using the TFTP client, upload the firmware file (extension .bin) to the Bullet2 or Nano/Loco2 IP address (192.168.1.20, by default). If the device doesn’t accept the firmware filename, rename it to “flash_update”. 
   - Signal LEDs will be blinking during firmware upgrade. 
   - Wait for about 7 minutes (Warning: Do not disconnect the Ethernet cable during procedure).

Configuring IP addressl

Once you finish these steps your device will have the OpenWRT firmware loaded. Then point your web browser at 192.168.1.1 and proceed by setting a password for the root (administrative) account.

Recovery procedure Recovery Ubiquiti Firmwarel

   Ubiquiti AirOS firmware can be downloaded from http://www.ubnt.com/support/airos.php

   - First of all, disconnect the Ethernet cable from the device. 
   - Connect the Ethernet Cable and immediately press the Reset button (near the device’s RJ45 connector) for 10 seconds. 
   - Make sure that Bullet2 or Nano/Loco2 responds to pinging (command: ping 192.168.1.20, by default). If not, please repeat previous steps. 
   - Using the TFTP client, upload the firmware file (extension .bin) to the device IP address (192.168.1.20, by default). If it doesn’t accept the firmware filename, rename it to “flash_update”. 
   - Signal LEDs will be blinking during firmware upgrade. 
   - Wait for about 7 minutes (Warning: Do not disconnect the Ethernet cable during procedure). 
   - Now the device should be alive and with the AirOS firmware loaded.

UBNT: openwrt

Referensi

Pranala Menarik

Navigation menu

Search