Arduino: Ethernet UDP Send isi Analog Input
/*
UDPSendAnalogInput: created 27 Nov 2015 by Onno W. Purbo This code is in the public domain. */ #include <SPI.h> // needed for Arduino versions later than 0018 #include <Ethernet.h> #include <EthernetUdp.h> // UDP library from: bjoern@cs.stanford.edu 12/30/2008 // Enter a MAC address and IP address for your controller below. // The IP address will be dependent on your local network: byte mac[] = { 0xDE, 0xAD, 0xBE, 0xEF, 0xFE, 0xED }; IPAddress ip(192, 168, 0, 3); unsigned int localPort = 8888; // local port to listen on // An EthernetUDP instance to let us send and receive packets over UDP EthernetUDP Udp; IPAddress remoteIP(192,168,0,102); unsigned int remotePort = 8888; void setup() { // start the Ethernet and UDP: Ethernet.begin(mac, ip); Udp.begin(localPort); Serial.begin(9600); } void loop() { Udp.beginPacket(remoteIP, remotePort); // output the value of each analog input pin for (int analogChannel = 0; analogChannel < 6; analogChannel++) { int sensorReading = analogRead(analogChannel); Udp.write("analog input "); Udp.print(analogChannel); Udp.write(" is "); Udp.print(sensorReading); Udp.write("\n"); } Udp.endPacket(); delay(100); }
Menerima Menggunakan nc
ifconfig eth0 192.168.0.102
nc -ul 8888
Akan keluar
analog input 0 is 1023 analog input 1 is 1023 analog input 2 is 995 analog input 3 is 992 analog input 4 is 1010 analog input 5 is 967
Menerima Menggunakan python
Source udp_receiver.py
import socket import time UDP_IP = "192.168.0.102" UDP_PORT = 8888 sock = socket.socket(socket.AF_INET, # Internet socket.SOCK_DGRAM) # UDP sock.bind((UDP_IP, UDP_PORT)) while True: data, addr = sock.recvfrom(1024) # buffer size is 1024 bytes print time.strftime('%X %x %Z'), "\n", data
Jalankan
python udp_receiver.py
Hasil
09:56:18 11/27/15 WIB analog input 0 is 1023 analog input 1 is 1023 analog input 2 is 1014 analog input 3 is 970 analog input 4 is 910 analog input 5 is 856