OpenWRT: Flash Linksys E900

From OnnoWiki
Revision as of 14:18, 11 January 2015 by Onnowpurbo (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

Spesifikasi

CPU 	Broadcom BCM5357
CPU Speed 	300 MHz
Flash ROM 	8 MB
RAM 	32 MB
Radio 	2.4 GHz
WLAN Support 	b/g/n
WLAN Max Speed 	300 mbps
Antenna Location 	Internal
MIMO Config 	2 Transmit x 2 Receieve
Switch 	4x 10/100 LAN + 1 10/100 WAN
USB Port 	None

After using the trailed build file for the initial flash (yes the file with the router name in it) only use nv64k builds to upgrade with or you will brick your unit. Don't confuse this unit with some of the other Linksys E-Series units that use nv60k builds, this one uses nv64k builds!

  • Read the Peacock Announcement carefully.
  • Disconnect all cables and wireless clients.
  • Do a 30/30/30 reset on router
  • Connect 1 Lan cable to pc doing the flash.
  • Log into Linkysys Web Interface Firmware Upgrade page at 192.168.1.1 and flash the firmware E900 Trailed Initial Flash Build
  • Wait 5 minutes to assure flash integrity.
  • Power cycle by unplugging the E900 for 10 seconds.
  • Plug the E900 back in and wait about 2 minutes until it finishes booting.
  • Do a 30/30/30 reset on router. Another power cycle may be required after hard reset as noted by some forum users.
  • Wait 3 minutes and log into web interface.
  • You are done.

After the initial flash - should you want to flash to a build with more features you can use a k2.6 nv64k BIG or mega build or any of the other build flavors that are of your liking for features.

For upgrading to a newer build you can follow these steps: http://www.dd-wrt.com/phpBB2/viewtopic.php?t=176523

ftp://ftp.dd-wrt.com/others/eko/BrainSlayer-V24-preSP2/2013/05-27-2013-r21676/broadcom_K26/dd-wrt.v24-21676_NEWD-2_K2.6_big-nv64k.bin 


Referensi