IPv6 AutoConfiguration: Stateless auto-configuration
Revision as of 13:46, 27 June 2013 by Onnowpurbo (talk | contribs)
16.1. Stateless auto-configuration
Is supported and seen on the assigned link-local address after an IPv6-enabled interface is up.
Example:
# ip -6 addr show dev eth0 scope link
2: eth0: <BROADCAST,MULTICAST,UP> mtu 1500 qlen1000
inet6 fe80::211:d8ff:fe6b:f0f5/64 scope link
valid_lft forever preferred_lft forever