Difference between revisions of "Juniper: Shutdown Reboot"

Revision as of 18:53, 24 December 2018

request system zeroize

request system power-off

request system halt

Wait until a message appears on the console confirming that the operating system has halted. For information about the request system halt command, see the Junos OS command documentation.
Disconnect power from the switch by pulling out the male end of the power cord connected the power source outlet.

request system reboot

This command will also notify other users connected to the switch about the operation.

@@ Line 1: / Line 1: @@
+==Reset / Meng-NOL-kan System==
+ request system zeroize
-==To Power Off the switch from CLI:==
-CLI command
+==Power off==
   request system power-off
- request system zeroize
-==To halt the switch from CLI:==
-Use the CLI command request system halt. On the console or other management device connected to the switch (to the master switch in a virtual chassis), enter the CLI operational mode and issue the following command to shut down the switch software:
+==Halt==
   request system halt
@@ Line 17: / Line 16: @@
 * Disconnect power from the switch by pulling out the male end of the power cord connected the power source outlet.
-==To restart the switch from the CLI:==
+==Reboot==
-Use the command
   request system reboot
@@ Line 27: / Line 24: @@
 ==To restart the switch from the front panel:==
-    From the LCD front panel menu push the Menu button.
+* From the LCD front panel menu push the Menu button.
-    When the MAIN MENU (Maintenance menu) appears, press the Enter button.
+* When the MAIN MENU (Maintenance menu) appears, press the Enter button.
-    Select the SYSTEM REBOOT option and press the Enter button.
+* Select the SYSTEM REBOOT option and press the Enter button.
-    To exit the menu without rebooting the switch, press the Menu button again.
+* To exit the menu without rebooting the switch, press the Menu button again.