Difference between revisions of "Juniper: Shutdown Reboot"

From OnnoWiki
Jump to navigation Jump to search
(Created page with " ==To Power Off the switch from CLI:== Use the CLI command request system power-off from operational mode, which displays a message to the CLI, then disconnect the switch fr...")
 
 
(6 intermediate revisions by the same user not shown)
Line 1: Line 1:
 +
==Reset / Meng-NOL-kan System==
  
 +
request system zeroize
  
==To Power Off the switch from CLI:==
 
  
Use the CLI command request system power-off from operational mode, which displays a message to the CLI, then disconnect the switch from electrical power.  This command will also notify other users connected to the switch about the operation.
+
==Power off==
  
==To halt the switch from CLI:==
+
request system power-off
  
Use the CLI command request system halt. On the console or other management device connected to the switch (to the master switch in a virtual chassis), enter the CLI operational mode and issue the following command to shut down the switch software:
 
  
user@switch> request system halt
+
==Halt==
  
    Wait until a message appears on the console confirming that the operating system has halted. For information about the request system halt command, see the Junos OS command documentation.
+
request system halt
    Disconnect power from the switch by pulling out the male end of the power cord connected the power source outlet. 
 
  
==To restart the switch from the CLI:==
+
* Wait until a message appears on the console confirming that the operating system has halted. For information about the request system halt command, see the Junos OS command documentation.
 +
* Disconnect power from the switch by pulling out the male end of the power cord connected the power source outlet.
  
Use the command request system reboot. This command will also notify other users connected to the switch about the operation.
+
==Reboot==
 +
 
 +
request system reboot
 +
 
 +
This command will also notify other users connected to the switch about the operation.
  
 
==To restart the switch from the front panel:==
 
==To restart the switch from the front panel:==
  
    From the LCD front panel menu push the Menu button.
+
* From the LCD front panel menu push the Menu button.
    When the MAIN MENU (Maintenance menu) appears, press the Enter button.
+
* When the MAIN MENU (Maintenance menu) appears, press the Enter button.
    Select the SYSTEM REBOOT option and press the Enter button.
+
* Select the SYSTEM REBOOT option and press the Enter button.
    To exit the menu without rebooting the switch, press the Menu button again.
+
* To exit the menu without rebooting the switch, press the Menu button again.
 +
 
 +
==Pranala Menarik==
 +
 
 +
* [[Juniper]]

Latest revision as of 03:53, 25 December 2018

Reset / Meng-NOL-kan System

request system zeroize


Power off

request system power-off


Halt

request system halt
  • Wait until a message appears on the console confirming that the operating system has halted. For information about the request system halt command, see the Junos OS command documentation.
  • Disconnect power from the switch by pulling out the male end of the power cord connected the power source outlet.

Reboot

request system reboot

This command will also notify other users connected to the switch about the operation.

To restart the switch from the front panel:

  • From the LCD front panel menu push the Menu button.
  • When the MAIN MENU (Maintenance menu) appears, press the Enter button.
  • Select the SYSTEM REBOOT option and press the Enter button.
  • To exit the menu without rebooting the switch, press the Menu button again.

Pranala Menarik