Difference between revisions of "Cisco: Konfigurasi Dasar"

Revision as of 10:16, 21 September 2015

Sumber: http://www.cisco.com/c/en/us/td/docs/routers/access/1800/1801/software/configuration/guide/scg/routconf.html#65645

Configure Global Parameters

Router> enable
Router# configure terminal
Router(config)#

Router(config)# hostname Router
Router(config)#

Configure the Fast Ethernet WAN Interface

Router(config)# interface fastethernet 0
Router(config-int)#

Router(config-int)# ip address 192.1.12.2 255.255.255.0
Router(config-int)#

Router(config-int)# no shutdown
Router(config-int)#

Router(config-int)# exit
Router(config)#

==Menyimpan Konfigurasi

copy running-config startup-config
write memory

Referensi

http://www.cisco.com/c/en/us/td/docs/routers/access/1800/1801/software/configuration/guide/scg/routconf.html#65645

@@ Line 3: / Line 3: @@
 ==Configure Global Parameters==
-Perform these steps to configure selected global parameters for your router:
-Command
-Purpose
-Step 1
-configure terminal
-Example:
   Router> enable
   Router# configure terminal
   Router(config)#
-Enters global configuration mode, when using the console port.
-If you are connecting to the router using a remote terminal, use the following:
-telnet router name or address
- Login: login id
- Password: *********
- Router> enable
-Step 2
- hostname name
-Example:
   Router(config)# hostname Router
   Router(config)#
-Specifies the name for the router.
-Step 3
-enable secret password
-Example:
- Router(config)# enable secret cr1ny5ho
- Router(config)#
-Specifies an encrypted password to prevent unauthorized access to the router.
-Step 4
- no ip domain-lookup
-Example:
- Router(config)# no ip domain-lookup Router(config)#
@@ Line 72: / Line 15: @@
 ==Configure the Fast Ethernet WAN Interface==
-This procedure applies only to the Cisco 1811 and Cisco 1812 router models. Perform these steps to configure the Fast Ethernet interfaces, beginning in global configuration mode.
-Command
-Purpose
-Step 1
-interface type number
-Example:
   Router(config)# interface fastethernet 0
   Router(config-int)#
-Enters the configuration mode for a Fast Ethernet WAN interface on the router.
-Note Fast Ethernet WAN ports are numbered 0–1 on the Cisco 1800 series routers.
-Step 2
-ip address ip-address mask
-Example:
   Router(config-int)# ip address 192.1.12.2 255.255.255.0
   Router(config-int)#
-Sets the IP address and subnet mask for the specified Fast Ethernet interface.
-Step 3
-no shutdown
-Example:
   Router(config-int)# no shutdown
   Router(config-int)#
+ Router(config-int)# exit
+ Router(config)#
-Enables the Ethernet interface, changing its state from administratively down to administratively up.
-Step 4
+==Menyimpan Konfigurasi
-exit
+ copy running-config startup-config
+ write memory
-Example:
- Router(config-int)# exit
- Router(config)#

Difference between revisions of "Cisco: Konfigurasi Dasar"

Revision as of 10:16, 21 September 2015

Configure Global Parameters

Configure the Fast Ethernet WAN Interface

Referensi

Navigation menu

Search