Onnowpurbo at 23:23, 19 November 2015

2015-11-19T23:23:41Z

Onnowpurbo: New page: Sumber: https://www.arduino.cc/en/Reference/Ethernet ==Referensi== * https://www.arduino.cc/en/Reference/Ethernet

2015-11-19T23:23:01Z

New page: Sumber: https://www.arduino.cc/en/Reference/Ethernet ==Referensi== * https://www.arduino.cc/en/Reference/Ethernet

New page

Sumber: https://www.arduino.cc/en/Reference/Ethernet

==Referensi==

* https://www.arduino.cc/en/Reference/Ethernet

← Older revision		Revision as of 23:23, 19 November 2015
Line 1:		Line 1:
	Sumber: https://www.arduino.cc/en/Reference/Ethernet		Sumber: https://www.arduino.cc/en/Reference/Ethernet
		+
		+	Ethernet library
		+
		+	With the Arduino Ethernet Shield, this library allows an Arduino board to connect to the internet. It can serve as either a server accepting incoming connections or a client making outgoing ones. The library supports up to four concurrent connection (incoming or outgoing or a combination).
		+
		+	Arduino communicates with the shield using the SPI bus. This is on digital pins 11, 12, and 13 on the Uno and pins 50, 51, and 52 on the Mega. On both boards, pin 10 is used as SS. On the Mega, the hardware SS pin, 53, is not used to select the W5100, but it must be kept as an output or the SPI interface won't work.
		+
		+
		+
		+
		+	Ethernet class
		+
		+	The Ethernet class initializes the ethernet library and network settings.
		+
		+	begin()
		+	localIP()
		+	maintain()
		+
		+	IPAddress class
		+
		+	The IPAddress class works with local and remote IP addressing.
		+
		+	IPAddress()
		+
		+	Server class
		+
		+	The Server class creates servers which can send data to and receive data from connected clients (programs running on other computers or devices).
		+
		+	Server
		+	EthernetServer()
		+	begin()
		+	available()
		+	write()
		+	print()
		+	println()
		+
		+	Client class
		+
		+	The client class creates clients that can connect to servers and send and receive data.
		+
		+	Client
		+	EthernetClient()
		+	if (EthernetClient)
		+	connected()
		+	connect()
		+	write()
		+	print()
		+	println()
		+	available()
		+	read()
		+	flush()
		+	stop()
		+
		+	EthernetUDP class
		+
		+	The EthernetUDP class enables UDP message to be sent and received.
		+
		+	begin()
		+	read()
		+	write()
		+	beginPacket()
		+	endPacket()
		+	parsePacket()
		+	available()
		+	stop()
		+	remoteIP()
		+	remotePort()
		+

Arduino: Ethernet Library - Revision history

Onnowpurbo at 23:23, 19 November 2015

Onnowpurbo: New page: Sumber: https://www.arduino.cc/en/Reference/Ethernet ==Referensi== * https://www.arduino.cc/en/Reference/Ethernet