View source for Balun Buatan Sendiri 1:1

Sumber: http://195.84.101.101/~goranl/building/aircore_balun/index.html



- 1:1 HomeBrew AirCore Balun -
2007.05.20 Made this 'AirCore' balun for use with a singe band portable 80M dipole. The manufacturing is quite simple and the result is a nice and very 'Heavy Duty' baluna.

This type of balun is normally used with broad-band or multi-band wire antennas,- where gamma-match or other narrow-band matching is not suitable. The baluna is also suitable for use with logo-periodic or multi-band directional Yagi antennas.

[[Image:Aircore balun.jpg|center|200px|thumb]]

- Technical data -

SPECIFICATIONS
========================================
Frequency responce ... 3-30 MHz
Maximun Input Power .. At least 1 KW
Input Impedance ...... 50ohm unbalanced 
Impedance ratio ...... 1:1 (In/Out)
Dimensions ...........
Weight ...............


- Making the balun -


[[Image:Balun coil layout1d1.jpg|center|200px|thumb]]

Principle - The coils on an air balun is not different from an Ferrite-balun, in the layout above you see the principle. Two coils (Yellow & red) is used as straight thru-feed, one for center conductor an the other for the shield conductor, they are connected directly to each dipole half, The blue coil is used for reversed 'pick-up' and balances the dipole connections.

[[Image:Balun d1.jpg|center|200px|thumb]]

The Air-balun is made on a plastic 'Nonconducting' core,- Use a pice of plastic tubing about 25mm in diameter and about 66mm long. Drill tree 2mm holes,- slightly in diagonal in one end, whith about 5mm distance. drill tree 2mm holes in the same manner in the other end of the tube,- distance between the two hole-rows is 49mm.

(On the images below i use 2mm Cu wire, the measurements given in this text is calculated using 1,5mm cu-wire)

[[Image:Closeup2.jpg|center|200px|thumb]]

Ready made coil and the test setup

Hint! It is best to make one coil at the time, dont trye to put al tree on the core at once.

- Testing the balun -
To this moment my only test is the frequency respons shown here. I also need to make som loss/return loss measurements.

[[Image:Respons setup.jpg|center|200px|thumb]]

Test setup


Frequency response using mini-vna


Parts before final assembly


Inside of so-239 connector at balun bottom


Connection cable to balune core connections


Internal assembly for the antenna Wire attachment and hanger pulley


Drain hole at balun bottom


Antenna Wire attachment and connections



==Referensi==

* http://195.84.101.101/~goranl/building/aircore_balun/index.html